RAD Data comm Optimux-106 Specifications download pdf (Page 17)

Optimux-106 Ver. 6.1 Connecting the Interface Cables 1

Quick Start Guide

If you are familiar with the Optimux-106, use this guide to prepare it for

operation. Perform the following steps.

1. Connecting the Interface Cables

Connecting the Tributary T1 Interfaces

³ To connect T1 interface (RJ-45 connector)

• Connect the RJ-45 connector of the cable to the T1 port.

Connecting the USER-ETH interface

³ To connect the USER-ETH interface

• Connect the RJ-45 connector of the cable to the USER-ETH port.

Connecting the Uplink

³ To connect the uplink

1. Clean the optical connectors using an approved solvent, and dry thoroughly

using optical tissue.

2. Connect to the two optical connectors designated TX (transmit output) and

RX (receive input) of the appropriate interface.

3. Pay attention to correct connection of the transmit and receive cables to the

corresponding connectors. Avoid sharp bends and twisting of the fiber-optic

cables.

For WDM option, only one fiber optic cable per link should be connected.

Note

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 109 110

No comments

RAD Data comm Optimux-106 Specifications Page 17