RAD Data comm MPW-1 Specifications download pdf (Page 41)

MPW-1 MP-4100 Ver. 2.0 Installing the Module 2-1

Chapter 2

Installation

This Chapter provides installation and setup instructions for MPW-1 modules.

The information presented in this Chapter supplements the general

Megaplex-4100 installation, configuration and operation instructions contained in

the

Megaplex-4100 Installation and Operation Manual

2.1 Installing the Module

MPW-1 modules may be installed in an operating unit (hot insertion).

Before performing any internal settings, adjustment, maintenance, or repairs,

first disconnect all the cables from the module, and then remove the module

from the Megaplex enclosure.

No internal settings, adjustment, maintenance, and repairs may be performed by

either the operator or the user; such activities may be performed only by a skilled

technician who is aware of the hazards involved.

Always observe standard safety precautions during installation, operation, and

maintenance of this product.

The MPW-1 module contains components sensitive to electrostatic discharge

(ESD). To prevent ESD damage, always hold the module by its sides, and do not

touch the module components or connectors.

To prevent physical damage to the electronic components assembled on the two

sides of the module printed circuit boards (PCB) while it is inserted into its

chassis slot, support the module while sliding it into position and make sure that

its components do not touch the chassis structure, nor other modules.

Preparations for Installation

No preparations are required for MPW-1 modules with RJ-45 copper interfaces.

For MPW-1 modules equipped with SFPs, it may be necessary to install, or

replace, SFPs.

MPW-1 modules have three installation positions for SFPs, designated ETH1,

ETH2, and ETH3:

• To install an SFP, use the procedure given in the

Installing an SFP

section.

• To replace an SFP, use the procedure given in the

Replacing an SFP

section.

Warning

Caution

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 107 108

No comments

RAD Data comm MPW-1 Specifications Page 41