Installation and Operation Manual Chapter 6 Troubleshooting and Diagnostics
IPmux-11 Ver. 2.00 Testing IPmux-11 6-21
Diagnostics>Ping
1. Destination IP address ... (0.0.0.0)
2. VLAN tagging (Enable)
3. VLAN ID[1 - 4095] ... (0)
4. VLAN priority[0 - 7] ... (0)
5. Number of frames to send[1 - 4] ... (1)
6. Ping send
>
Please select item <1 to 6>
ESC-prev.menu; !-main menu; &-exit 1 Mngr/s
Figure 6-17. Ping Menu
Running a Trace Route
You can run a trace route to a remote IP host to check the IPmux-11 IP
connectivity.
To run a trace route to an IP host:
1. From the Diagnostics menu (
Figure 6-4), select Trace route.
The Trace route menu appears (see
Figure 6-18).
2. From the Trace route menu, configure the following:
Destination IP Address (IP address of the host to which you intend to trace
the route): 0.0.0.0 to 255.255.255.255.
VLAN Tagging:
Enable (VLAN tagging is enabled)
Disable (VLAN tagging is disabled)
VLAN ID: 1–4095
VLAN Priority: 0–7
The VLAN ID and VLAN Priority configuration is available only if the VLAN tagging is
enabled.
3. Select Trace route send to start the trace route.
Note
Comments to this Manuals