RAD Data comm Vmux-210 Technical Information download pdf (Page 16)

Chapter 2 Installation and Operation User's Manual

2-6 Using the Graphical User Interface Vmux-210 Ver. 1.0

Edit and Agent Modes

The Element Manager window contains two Vmux-210 images, one above the

other. The two images provide two configuration modes:

• Edit mode (the upper image) – modifies the temporary configuration, stored

at the Network Management Station

• Agent mode (the lower image) – configures the agent located within the

physical Vmux-210 device (the active configuration).

 To select Edit Mode:

• In the Element Manager window, click the top image

 To select Agent Mode:

• In the Element Manager window, click the bottom image

When Agent mode is selected, the focus is on the configuration of the actual

physical Vmux-210 (the active configuration).

Displaying the Agent Mode View

The Agent View command enables you to display or hide the Agent mode view.

 To display or hide the Agent Mode View:

1. Select the device.

2. From the Window menu, select Agent View.

If the Agent mode view was previously hidden, a check mark appears next

to the Agent View entry in the menu and the Agent mode view appears. If

the Agent mode view is already visible, the Agent mode view disappears.

The Window menu is only enabled when there is communication with the Agent.

LEDs

The Agent mode front and rear panels of the Vmux-210 include LED indicators

that show the current operating status of the device.

Table 2-1 describes the

indicators.

Note

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 137 138

No comments

RAD Data comm Vmux-210 Technical Information Page 16