RAD Data comm IPmux-8 Specifications Page 99
- Page / 116
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
IPmux-11 Installation and Operation Manual Appendix D Configuration Menus
Configuring IPmux-11 at the Physical Level D-15
Configuration>Physical layer>TDM (T1) configuration
...(P)
9. Send upon fail (OOS Code)
10. OOS code[0 - ff] ... (FF)
11. Signaling mode (Robbed Bit)
12. OOS signaling > (Space)
13. Mark signaling code[0 - f] ... (D)
14. Space signaling code[0 - f] ... (1)
>
Please select item <1 to 14>
ESC-prev.menu; !-main menu; &-exit 1 Mngr/s
Figure D-20. TDM (T1) Configuration Menu (Page 2)
Configuring Ethernet Interfaces
IPmux-11 includes one network and up to two user Ethernet ports.
To configure Ethernet interface:
1. From the Physical Layer menu (Figure D-16), select ETH Configuration.
The ETH Configuration menu appears (see Figure D-21).
2. From the ETH Configuration menu, type F to select the Ethernet interface that
you intend to configure (Network-Eth1, User1-Eth2 or User2-Eth3).
3. When the required Ethernet interface is displayed, configure the following:
Channel state:
Enable (Current Ethernet interface is enabled)
Disable (Current Ethernet interface is disabled)
Auto negotiation:
Enable (Autonegotiation is enabled)
Disable (Autonegotiation is disabled)
Max capability advertised (Maximum capability to be advertised during the
autonegotiation process):
10BaseT Half Duplex
10BaseT Full Duplex
100BaseT Half Duplex
100BaseT Full Duplex
Default type (Rate and duplex mode, if the autonegotiation is disabled)
10BaseT Half Duplex
10BaseT Full Duplex
100BaseT Half Duplex
100BaseT Full Duplex
- IPmux-11 1
- Limited Warranty 4
- General Safety Instructions 5
- Handling Energized Products 6
- FCC-15 User Information 8
- Warning 9
- Quick Start Guide 11
- Configuring Internal Bridge 12
- Contents 13
- Table of Contents 14
- List of Figures 15
- List of Tables 16
- Chapter 1 17
- Introduction 17
- Features 18
- To calculate distance: 19
- TDMoIP Operation Modes 19
- Management 20
- 1.2 Physical Description 20
- 1.3 Functional Description 21
- External Network Timing 22
- Single Source Clock Network 23
- MAC IP UDP 24
- Packet Delay Variation 25
- PDVT (Jitter) Buffer 26
- Ethernet Throughput 27
- Round Trip Delay 28
- OAM Connectivity 29
- End-to-End Alarm Generation 29
- VLAN Traffic Behavior 30
- Ethernet Ports 30
- Rate Limiter Option 31
- 1-16 Functional Description 32
- Table 1-10. Mode C 33
- Table 1-11. Mode D 33
- Table 1-12. Mode E 34
- Table 1-13. Mode F 34
- Table 1-14. Mode G 35
- 1.4 Technical Specifications 36
- Chapter 2 39
- Installation and Setup 39
- 2.3 Installation and Setup 40
- Connecting AC Power 41
- Connecting DC Power 41
- Chapter 3 43
- Operation 43
- 3.2 Operating Instructions 44
- 3.3 Getting Started 45
- Choosing Options 46
- Saving Changes 46
- Web Browser Requirements 46
- Tdm Configuration (T1) 47
- ETH Configuration 47
- Diagnostics Ping 48
- Loopback 48
- Self Test Results 48
- 3.5 Default Settings 49
- 3-8 Default Settings 50
- Default Settings 3-9 51
- 3-10 Default Settings 52
- Chapter 4 53
- Diagnostics and 53
- Troubleshooting 53
- Displaying Events 54
- Clearing Events 55
- Table 4-1. Event List 56
- E1/T1 Statistics 58
- Table 4-2. E1/T1 Statistics 59
- LAN Statistics 62
- Bundle Connection Statistics 63
- 4.3 Diagnostic Tests 67
- 4-16 Diagnostic Tests 68
- 4.4 Troubleshooting 69
- 4.5 Alarm Relay 70
- A.1 E1 and T1 Connector 73
- A.2 Ethernet Connectors 74
- A.3 CONTROL Connector 74
- A.4 External Clock Connector 75
- Appendix B 77
- Boot Sequence and 77
- Downloading Software 77
- Software 78
- Appendix C 81
- SNMP Management 81
- MIB Structure 82
- SNMP Communities 83
- Authentication 84
- Network Management Stations 84
- Appendix D 85
- Configuration Menus 85
- Defining Network Managers 90
- Defining Management Access 91
- Configuring User Access 92
- Masking Alarms 93
- Control Port Parameters 94
- Setting Date and Time 94
- TR-6211 (10 seconds) 98
- Fast (1 Second) 98
- None 98
- Robbed Bit 98
- D.8 Resetting IPmux-11 107
- Figure D-32. Utilities Menu 108
- 48/60VDC~100-240VAC/ 109
- Customer Response Form 111
- Error Report 113
© 2020, manymanuals.com. All rights reserved. | 0.016 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals