DIAGNOSTICS
• IPmux-11 supports remote and
local loopback testing.
• Alarm detection and insertion are
supported together with error
statistics. These include SES/UAS
statistics, LOS/AIS physical layer
alarms, and remote/local loopback
test modes. Standard E1 or T1
alarms are transmitted
end-to-end.
• The following physical layer
alarms are supported: E1/T1 port
LOS, AIS, LOF, LCV.
• IPmux-11 performs an internal
built-in test (BIT) after power up.
The results of the test are visible
via the local terminal.
• IPmux-11 monitors LAN and IP
layer network condition statistics,
such as packet loss and packet
delay variation (jitter). The events
are stored in log files.
• Fault isolation, statistics and event
logging are available.
• The minor and major alarms can
be relayed to a remote alarm
device via dedicated pins of the
external clock RJ-45 connector.
MANAGEMENT
• IPmux-11 can be configured and
monitored locally via an ASCII
terminal, or remotely via Telnet,
Web browser or RADview.
• Management traffic can run over a
dedicated VLAN.
• The RADview Service Center and
Element Manager packages
control and monitor TDM over IP
(TDMoIP) devices and circuits.
The Service Center’s intuitive
GUI, “point-and-click”
functionality and easy-to-follow
wizards increase the efficiency
and accuracy of the service
provisioning process.
• Software download is supported
via the local terminal, using
XMODEM, or remotely, using
TFTP. After downloading a new
software version, IPmux-11
automatically saves the previous
version in non-volatile memory for
backup purposes. Similarly, copies
of the configuration file may be
downloaded and uploaded to a
remote workstation for backup
and restore purposes.
SPECIFICATIONS
E1 INTERFACE
• Compliance
ITU-T Rec. G.703, G.704, G.706,
G.732, G.823
• Data Rate
2.048 Mbps
• Line Code
HDB3
• Framing
Unframed, CRC-4 MF, CAS MF
• Signaling
CAS, CCS (transparent)
• Line Impedance
Balanced: 120Ω
Unbalanced: 75Ω
• Signal Levels
Receive: 0 to -36 dB with LTU
0 to -10 dB without LTU
Transmit balanced: ±3V ±10%
Transmit unbalanced: ±2.37V ±10%
• Jitter Performance
Per ITU-T G.823
• Connector
Balanced: RJ-45
Unbalanced: RJ-45 (RJ-45 to
BNC adapter cable is supplied)
Figure 2. LAN and TDM Services over a Wireless Ethernet Link
Order from: Cutter Networks
Ph:727-398-5252/Fax:727-397-9610
Comments to this Manuals